Five Tips for Updating To the Spiral Cutterhead
Home › Product News › Five Tips for Updating To the Spiral Cutterhead
Five Tips for Updating To the Spiral Cutterhead
There are five tips you should know before replacing the straight knife cutter to the spiral cutter head.
1. The original bearing should be checked for accuracy, and it is recommended to replace the new bearing. The bearings to be replaced shall adopt P5 low-noise, high-precision bearings.
2. Check the inner diameter of the bearing housing (due to the excessive wear and tear of the inner hole of the bearing for many years, it will cause high noise, and it will also cause the bearing to be damaged in a short period of time, making the bearing go inner or outer circle). It is a new bearing seat.
3. Before installing the bearing, check and clean the cutter head shaft and tool holder; add 3# white grease in the bearing; when installing the bearing, the bearing should be pressed in smoothly and evenly. (If there is hydraulic equipment, please use hydraulic equipment Install the bearing. If there is no hydraulic equipment, the steel sleeve should be used to contact the inner ring of the bearing and knock in evenly to avoid damage to the outer circle of the shaft head by single-sided knocking).
4. There are four cutting edge for woodworking planer blades. If one of the cutting edges of the blade is dull, you need to tighten the screw counterclockwise to clean the blade seat and blade. It is recommended to use gasoline or thinner to clean it easily. When changing the cutting edge surface, you must pay attention: the surface of each blade has a marking point, and it must be ensured that the uniform orientation is consistent to avoid the wrong surface of the new and old blades and cause the wood planing surface to be uneven.
5. If the screw is too tight or rusty and difficult to loosen, first put the bit into the torx hole of the screw and tap it lightly with a small hammer (be careful not to damage the blade), and then use a wrench to loosen it easily . In order to avoid the phenomenon that the screw is rusty and difficult to loosen when the blade is changed next time, it is recommended that the screw hole must be cleaned every time the knife is changed, and the screw must be moistened with oil and then screwed into the screw hole. This will ensure the next time It is easy to loosen the screws when changing the blade.
Any requests for woodworking spiral cutterhead, no matter tips for installing the spiral cutterhead, or changing the spiral cutter head instead of a straight knife cutter, just contact Our for more information.
Write a Comment