What’s the Process of Nail Making Machine?

What’s the Process of Nail Making Machine?

• Admin
• 2024/5/26

What is the process and operation method of nail making machine? Today, an experienced master from a steel nail manufacturer was specially appointed to give us a system introduction. The following content comes from the introduction of the master.

The production process of nails is mainly wire drawing, cold heading, polishing and other processes. It is relatively simple. The material of the nail is steel coil. After drawing, the diameter of the nail shaft is pulled out, and then cold heading, the tail and tip of the nail are made, and then the finished product is polished. If the surface of the nail is required to be electroplated, the process of blackening may be added.

Steel nail manufacturers buy steel bars from steel mills and use a wire drawing machine to process them into iron wires of appropriate diameters, then cut them with a nail making machine, punch the nail cover, and then polish each of the qualified nails. Small nails can be processed at one time on the nail making machine. The polishing machine is to put processed nails and saw foam inside and stir and rub the nails to polish them.

The nail making machine will complete all the processes of straightening steel bars, punching nail caps, and cutting nail tips.

The correct operation process of the nail making machine is as follows:

First, the material is drawn through the wire drawing machine to remove the rust, and drawn to the standard diameter of the nail you need;

Then enter the nail making machine to make round nails;

Load and polish The machine (participating materials) is poured out to the brightness you need;

Measuring, packaging, and leaving the factory.

Feeding: Use steel bars with a diameter of less than 8mm and a length of more than 10cm, cold drawn wires, welding rods, and coils as materials.

Parameter: This length of coil can produce round nails with specifications of 50-180 mm (2 inches, 2.5 inches, 3 inches, 4 inches, 5 inches, 6 inches, etc.).

As a supplier of wire tools, Our provides a variety of carbide nail tools for nail manufacturers around the world, including wire drawing dies used on wire drawing machines, bending rollers for mechanical descaling, nail cutters, nail gripper dies and punch heads on nail making machines. we could provide you with one-stop high-quality and worry-free services.

• SNMX Insert
• SNMU Cost-effective Insert
• BLMP Insert
• 16ER Insert
• SNMG120408-GN IC9150