For aluminum plate cutting, it is recommended to use a single-edged special router bit. No sticking to the knife during processing, fast speed, and high efficiency.
Cork, MDF, virgin wood, PVC, acrylic large-scale deep relief processing, the single-edged spiral ball-end woodworking router bits is recommended.
It is recommended to use single-edged, double-edged up and down cutters for cutting without burrs on the top and bottom.
For multi-layer board and splint processing, a double-edged straight groove milling cutter is recommended.
A diamond carving knife is recommended for acrylic mirror engraving.
For MDF cutting processing, it is recommended to use a double-edged large chip evacuation spiral milling cutter. It has two high-capacity chip evacuation grooves and a double-edged design, which not only has a good chip evacuation function but also achieves a good tool balance. When processing medium and high-density boards, it has the characteristics of no blackening, no smoking, and long service life.
A single-edged spiral router bit is recommended for acrylic cutting processing. It is characterized by being smokeless and odorless, fast, efficient, non-sticky, and truly environmentally friendly. Its special manufacturing process ensures that acrylic does not burst. , Very fine knife pattern (even no knife pattern), smooth and smooth surface. The machined surface needs to achieve a frosted effect. It is recommended to use a double-edged three-edged spiral milling cutter.
For high-density boards and solid wood, it is recommended to use edge cutters.
For precision small relief processing, a round bottom cutter is recommended.
The use effect of the lower cutter, the upper surface of the processed product is free of burrs, and the plate will not be warped during processing.
Multi-stripe milling cutters are recommended for rough processing of particleboard.
Write a Comment